PREMIER M PLUS USER MANUAL & MAINTENANCE GUIDE
Approved Document No: GLT.MAN-112 PAGE 8
Issue: 2.3 Author: NRPJ Date: 25/5/2017
Check the cause of the alarm activation. If the cause of the alarm was an activated call point, reset it (if resettable type),
or fit a new glass element (if glass type). If the cause of the alarm was by detector activation (e.g. cooking smoke), the
smoke will have to be cleared from the room before the panel can be reset. Reset the panel by pressing the reset button
after the sounders and panel buzzer have been silenced.
If the call point is still active, or the detector is still smoky, this will cause another alarm straight after the panel is reset, so
will set off the alarm bells again.
To Next Page
Loading...
