67
PLANNED TECHNICAL MAINTENANCE - LUBRICATION CHART
Pos. Lubrication point - inspection Fluid type
1
cooling system - coolant exchange antifreeze
2
pivot pin sliding bearing nipples PM - LA 2
3
engine - oil exchange see (tab. 1)
4
front wheel bearings PM - LA 2
5
FW rigid extensions (2 grease nipples) PM - LA 2
6
steering lever ball joints PM - LA 2
7
brake fluid reservoir Synthol 205
8
cab door hinges PM - LA 2
10
front wiper drive bearings see (tab. 5)
11
clutch release sleeve see (tab. 2)
12
steering wheel shaft column PM - LA 2
13
portal frames see (tab. 2)
14
disc brake rollers Termosize
15
telescopic control of lifting tie rod (1 nipple) PM - LA 2
16
right lifting tie rod of three-point hitch (1 nipple) PM - LA 2
17
tightening nuts of lower tie rods PM - LA 2
18
operator’s seat (handle and rollers of seat) PM - LA 2
19
rear wiper drive bearings see. (tab.5)
20
automatic traction gear for trailers (4 grease nipples) PM - LA 2
21
lower pin of three-point hitch support PM - LA 2
22
connecting rod of power control (1 grease nipple) PM - LA 2
23
lift assisting cylinder pins (2 or 4 lub. nipples) PM - LA 2
24
left-hand lifting arm journal PM - LA 2
25
power control torsion bar (1 grease nipple) PM - LA 2
27
operator’s seat suspension damper oil
28
push-pull cable of pick-up hitch, hand parking brake PM - LA 2
29
transmission see (tab. 2)
30
clutch disengagement shaft (2 grease nipples) PM - LA 2
To Next Page
Loading...
