52
TRACTOR OPERATION
E201
E202
E203
BEFORE ENGINE STARTING
Before starting the engine be sure that:
1. tractor is braked properly
2. main gearshift lever is in neu-
tral position.
If the clutch pedal is not de-
pressed, the tractor cannot be
started - the start safety switch is
not actuated.
Note: Before starting proper we recom-
mend to prime the fuel system by several
strokes of hand fuel delivery pump.
ENGINE STARTING
1. Insert the key into the ignition lock
("0" position).
2. Depress the clutch pedal.
3. Move the main gearshift lever into
neutral position.
4. Set throttle to increased fuel delivery
(approx. 1/2 of maximum delivery).
5. Turn the key from “0” position to "I"
position. The glow-plug indicator light
comes on.
6. Wait until the indicator light goes out
(the time depends on the coolant
temperature).
In case that the indicator light
flashes only instead of lighting,
the glowing system failed (see
Chapter Signalling of glowing
system failures). Have the indi-
cated failure corrected at the
authorized service centre.
7. Immediately after the indicator light
has gone out (max. within 5 s), turn
the key from position "I" into position
"II" (start).
8. Release the key immediately after
starting the engine, it returns auto-
matically into ”I” position. Do not op-
erate the starter for more than 15 s.
9. After starting the engine, gradually
reduce the fuel delivery.
To Next Page
Loading...
