5
Charging and Battery
The Visual Controller VC100 adopts internal built-in battery. When using the Visual
Controller VC100 for the first time, please fully charge it to activate the battery.
Charging and Battery
AC power
（100-240V）
USB charger Type-C cable ZHIYUN MasterEye
Visual Controller VC100
① When using the Visual Controller VC100 and the battery level is less than
10%, the indicator light will turn red and stay solid.
② Cannot charge external NP-F batteries.
Charging method: Use provided Type-C cable to connect with the USB charger (not
provided) to charge the Visual Controller VC100. It is recommended to use USB
chargers that meet the QC 2.0 or PD policy. (support 16W at most). When the four
indicator lights stay solid and blue, the charging is completed.
Charging time: Approximately 1 hour and 50 minutes (data collected with a 15W
charger that meets the QC 2.0 or PD policy and with the environment temperature
of 25℃ . The charging time may vary in other environmental factors and the actual
results may vary as well. When using the 5V/2A charger, the charging time is
approximately 2 hours and 16 minutes.)
Operation time (with a fully-charged battery) : Approximately 8 hours (data collected
with the environment temperature of 25℃ and the screen brightness is 50%).
To Next Page
Loading...
Need help?
General