Zhiyun WEEBILL-S User Manual

4
Preparing and Charging the Batteries
① Due to the differences of the charger itself, charging the batteries may fail when
the power supply is insufficient (for instance, when the current of the adapter is
lower than 500mA). Conditions may vary depending on the specific chargers
used. It is recommended to use an adapter with a higher current capacity.
② The battery cannot be charged through the USB port on the stabilizer.
① Please use a qualified standard 5V/ ≥ 2000mA adapter for battery charging;
charging time depends on the maximum input current of the adapter.
② This stabilizer comes standard with two high-discharge-rate dedicated batteries.
Please use and charge batteries provided or approved by ZHIYUN only.
③ Please make sure both the batteries are fully charged. Either battery
undercharged can lead to failure of the stabilizer.
USB Cable
Adapter
Power
Supply
Charging Procedure
1. Insert the batteries into the charger in the right direction (positive/negative end)
accordingly.
2. Connect the charger to the adapter via the Type-C USB cable.
3. Plug the adapter into a power outlet to start charging.

Zhiyun WEEBILL-S Specifications

General

Battery Runtime	up to 14 hours
Charging Time	2.5 hours
Bluetooth	Yes
Following Deviation in Motion State	±0.05°
Compatible Cameras	DSLR and mirrorless cameras
USB Port	USB Type-C
Battery Type	2 x 18650
Pan Range	-360° to +360°
Wi-Fi	Yes
Battery Capacity	2600 mAh
Following Deviation in Static State	±0.01°
Wireless Connectivity	Bluetooth, Wi-Fi
Mounting	1/4"-20 threaded hole
Stabilization	3-Axis
Control Interface	Buttons
Follow Modes	POV
Mount Type	Arca-Swiss