4
95
The following settings are possible in the cooling mode:
• The ventilator speed can be adjusted by pressing the -button
A
utomatic regulation of ventilator speed
High
Average
Low
• The temperature can be set between 18°C and 32°C (PH733: 16°C - 32°C) by
p
ressing the
G a
nd
H b
uttons. The display on the remote control shows the
set temperature.
DEHUMIDIFICATION
When the dehumidification mode is activated, the transparent ring around the
button on the front of the device
B turns YELLOW.
The dehumidification function can be used in different ways.
1) All models:
Only connect the air exhaust hose J to the air outlet D and lead it outside, as
when using the device in the cooling function with a single hose. Place the hose in
such a way that the hot air is expelled outside. The device will then dehumidify
the air in the room and remove excess moisture through the air hose.
2) All models:
Do not connect both the air supply I and the air exhaust hose J. Remove the
rubber plug from the water drain
K and ensure that the water that is removed
(e.g. through a drain hole in the floor). You can also connect a water hose to the
water drain (see chapter G).
3) PH733:
Connect the supplied water hose to the plug O that fits into the water drain.
Lead the other end to a drain or sink and insert the plug
O into the water drain
J. Do not connect both the air supply I and the air exhaust hose J. The
condensed water will be removed through the hose. The maximum rise may be
1.5 m from the floor on which the device is standing. Exceeding this distance may
damage the machine or cause leaks.
During the dehumidification, the ventilator speed can not be adjusted. The
speed changes automatically to medium. The
G and H buttons ar
e inactive.
G
A
TTENTION!
In the automatic mode, the condensed moistur
e is always r
emoved
through the air exhaust hose
J. Removing the rubber plug from the
water drain
K will allow the water to drain out at this point. The water
drain
L can not be used.
G
Whether the desired temperature can actually be reached depends on
the ambient conditions. The room temperature remaining above the set
temperature is normal.
D
ehumidifying mode (yellow)
man_uk_P7xx.qxd 08-11-2006 15:22 Pagina 95
To Next Page
