15
• Before your first training, get familiar with all the functions and
adjustments available for the device.
• Some parts of the device may corrode. It is, therefore,
inadvisable to leave the device in a room with a high moisture
content. Take care not to allow the device (in particular internal
and electronic components) to be exposed to water, beverages,
sweat, etc.
• The device is intended for adult training and is NOT a toy.
If you allow children to use it at your own discretion, you must
provide them with instructions of appropriate use and ensure
constant supervision.
• This is not a therapeutic device.
• Slight humming noise may be heard during operation due to the
inertial movement of the flywheel caused by the structure. It
does not affect the operation of the device.
For exercise bikes and elliptical trainers, any possible humming
noises heard when rotating the pedals backwards occur for
technical reasons and have no negative consequences.
• Noise emissions are greater when loaded.
• Before each training, make sure the protective devices are
operational and bolt and plug connections are tight.
• Wear appropriate (sports) shoes during the training.
MAINTENANCE
Carry out maintenance activities at regular intervals. The tasks listed
below should be carried out at least every 20 hours of operation.
• Check moving parts of the device. If they need lubrication, use
a bicycle bearing grease.
• Check the conditions of such parts as bolts and nuts.
Make sure they are tight.
• Wipe the sweat off the device after each training. Make sure
the display does not come in contact with water or moisture.
• Clean the product with soapy water only. Do not use cleaning
agents.
• Store the device in a dry and warm place.
• Do not expose the device to direct sunlight.
ENVIRONMENT
The device is delivered in a package to protect it against any possible
transport damage. The packaging is made from non-processed
material and can be recycled. Throw the materials to appropriate
colour containers for selective waste collection.
Protect the environment and do not throw used batteries into
household wastes. Return them to the point of sale or a special
recycling centre.
Used electrical equipment (including the computer and power supply)
are recyclable. Do not throw them out with household waste as they
may contain substances dangerous to the health and environment. You
can actively contribute to sustainable use of natural resources and the
protection of the natural environment by handing the used device to
a recycling centre for used electrical devices.
ASSEMBLY
The device must be assembled carefully by an adult. In case of doubt,
ask a more experienced person for help.
• Prior to the assembly, make sure the set contains all
the listed elements and whether none of the parts was damaged
during transport. If any parts are missing or you have any other
reservations, contact the seller.
• Have a look at the drawings and explanations and follow the
assembly manual when assembling the device.
• Be careful during the assembly. There is a risk of injury when
using the tools and parts.
• Remember to keep your surroundings safe. Do not let tools and
parts lie around in chaos. Remember that plastic foil and bags
pose o suffocation risk to small children.
• Assembly parts necessary for a specific step in
the assembly manual are shown in pictures and included in
instructions. Use the elements indicated in the assembly
manual.
• Do not tighten parts completely during the first stages
of the assembly. Tighten connections after all parts are placed
and fitted properly.
• The manufacturer may have assembled some parts.
ASSEMBLY DIAGRAM (→ See page 2)
ATTENTION! Do not use parts other than those provided by the manufacturer.
PARTS LIST
Front cover of pedal bases
Hexagonal bolt Φ12xM10x80
Rear cover of pedal bases
Rear cover of pedal bases
Cross Tapping Screw ST4.2x18
Cross Tapping Screw ST3.5x13
Curved washer Φ8xΦ20x2xR30
D Shape washer ΦO28xΦI16.2x14xB5
To Next Page
Loading...
