Need help?Do you have a question about the Ziton ZP880 Series and is the answer not in the manual?
Intelligent Addressable Weatherproof Manual Call Point for outdoor use supporting Ziton ZP7 protocol.
Units supplied with a resettable element, replaceable with a breakable element (N-MC-FE).
Set device address using DIP switch on back of front assembly. Range 001-127.
Mount backbox using M4 screws and feed loop cable through gland. Remove dust cover after commissioning.
Use 0.13-3.31 mm² twisted-pair cable, max 2.8 km. Observe polarity.
Two colour changing LEDs indicate Alarm (red), Fault (yellow), Communicating (red).
Maintain and test per local/national requirements. Do not modify internal wiring.
Activate an alarm by pushing the element or turning the key clockwise (one click). Reset device by turning key anticlockwise (one click).
Unlock and remove front cover, push element up and pull out, replace element, replace front cover.
Table shows analogue values for Normal (88) and Alarm (148) device statuses.
Operating voltage 16-20 VDC. Current consumption Standby 250 µA, Alarm 280 µA.
IP rating IP67. Backbox cable knockouts (MK20). Wire size 0.13-3.31 mm². Temp -25 to +72°C.
Summary of declared performance according to Construction Products Regulation (EU) 305/2011.
CE conformity, Notified Body 0370, Manufacturer Carrier Safety System (Hebei) Co. Ltd.
For contact information or to download latest product documentation, visit firesecurityproducts.com.
General| Brand | Ziton |
|---|---|
| Model | ZP880 Series |
| Category | Security System |
| Language | English |
To Next Page
