Need help?Do you have a question about the Ziton ZP888R and is the answer not in the manual?
The ZP880 Series Intelligent Addressable Weatherproof Manual Call Point is designed for outdoor use and supports the Ziton ZP7 protocol.
All units are supplied with a resettable element that can be replaced with a breakable element if required.
Set the device address using the DIP switch on the back of the front assembly. The address range is 001-127.
The manual call point is surface mounted. Screw cable glands, fix backbox to wall, feed cable, and secure front assembly.
Use 0.13 to 3.31 mm² twisted-pair cable with a maximum length of 2.8 km. Observe polarity for connections.
The device status is indicated by two colour changing LEDs: Flashing red for Alarm, Flashing yellow for Fault.
Unit should be maintained and tested according to local or national requirements. Do not modify internal wiring or circuitry.
Procedure to replace the resettable element: unlock cover, push element up, pull out, replace, and reattach cover.
Details operating voltage (16-20 VDC) and current consumption (Standby 250 µA, Alarm 280 µA).
Covers IP rating (IP67), cable knockouts, wire size, operating temperature (-25 to +72°C), and humidity.
Summarizes declaration of performance according to EU regulations, including CE marking and notified body details.
General| Brand | Ziton |
|---|---|
| Model | ZP888R |
| Category | Security System |
| Language | English |
To Next Page
