51
II - Abbreviated Operating Procedures
Step 1
Install the F707/708 and power it up.
Step 2
Enroll users by registering his/her fingerprints or passwords. If the
F707/708 is operating in stand-alone mode (where no 3
rd
party access
control panel exists), assign users’ security privileges directly on the
F707/708.
If using the F707/708 with a 3
rd
party Wiegand access control panel, users’
security privileges will be maintained by the access control panel and
NOT the F707/708.
Step 3
After enrolling user(s), verify his/her enrolled fingerprint(s) or password is
recognized by the F707/708.
Step 4
:
Configure the F707/708 communication settings. Then download the
users’ newly enrolled fingerprints from the F707/708 onto a computer.
Data can be transmitted via TCP/IP or by a cross-over cable and laptop
computer
Note;
We always recommend backing up the fingerprint templates on to a
computer or removable media. If the F707/708 ever fails or is
vandalized, having a “backup” eliminates the need of having to
re-enroll all your users all over again. Having a “template backup”
can potentially save you a lot of time.
Step 5
Verify the F707/708 displays the correct day and time
To Next Page
Loading...
