201 Circle Drive N, Suite 116 Piscataway, NJ 08854 Tel: 732-412-6007 Fax: 732-412-6008
www.zkaccess.com
5. Parameter settings of card reader
The parameters of KR300 card reader can be read and set by the control system of Wiegand reader.
The control system of Wiegand reader can set the baud rate of RS232 communication, Wiegand model,
Wiegand control, as well as Settings about Mifare card. When setting for Mifare card, please place
Mifare card on the effective sense area of card reader till the complete setting, otherwise the invalid
operation.
The operations about the control system of Wiegand reader:
Open directly, the following window is displayed:
The software window is divided into two parts: the left is to display read and write status, and the right is
to display three operational windows of COM setting, System setting, and S50/S70. Three operational
windows are switched by three corresponding buttons at the bottom.
To Next Page
Loading...
Need help?
General