ZKTeco AL-300 - User Manual

To Next Page

Wiring: 1. One diode is an accessory provided in the accessory bag. The diode is used to prevent bounce-back current and voltage produced

during locking or unlocking from affecting the access control mainframe. Users can connect the diode to the wiring terminal in parallel.

Precautions: 1. Read this User Manual carefully before installing the electric strike.

2. Select qualified power source and wires to avoid insufficient locking force caused by abnormal power supply.

3. This lock has no delay function. If delay function is necessary, it shall be used together with the controller.

Welcome to use Advanced Lock products. In order to protect your rights and interests, read this User Manual carefully before use. Please contact the dealer or the

manufacturer in case of query.

AL-130 Series Electric Strike User Manual

Applicable Range: This lock is applicable for use together with anode mechanical lock or ball lock in office buildings, wooden doors, stainless steel doors, fire doors and

entrance gate of residence community.

Product Advantage: Recessed type installation and pleasant-looking appearance. The electromagnetic part adopts high-quality magnetic materials and special processing workmanship

to ensure normal use and no residual magnetism even after long time operation.

Door Opening: 90 and available for load of 250kg

Electrical Property: Users can select appropriate products with different models and functions based on the following table. Customization is available according to users' requirements.

12 V 15 %

Model

Voltage (DC)

Current (mA)

AL-130NO

AL-130NC

24 0

12 0

Mechanical

Lock

3-5mm

1mm

AL-1 30 Series Electr ic Str ike Installa tio n Drawin g

Electric strikes

Electric

strike

135

149

(2 000 )量认(国)字( H09 92 )号

太平洋承保

质

AL-130NO

GND

PUSH

12V

GND

12V

UPS Control

NO COM

GND

PUSH

12V

GND

12V

UPS Control

NO COM

AL-130NC

Access control power source

N0 - unlock by

connecting power

NC - unlock by

disconnecting power

ELECTRIC LOCKS

Access controller

12 V 15 %

Customization is available for

products with 6-24VDC;

Access control power source

Access controller

Fig.1

Latch

Installation Precautions:

1.Allow a 1-2mm gap between the electric strike and the bolt of electric dropbolt. Otherwise, normal door

opening will be affected. (See Fig.1)

2.Allow a 3-5mm gap between the electric strike and the face plate of electric dropbolt. Otherwise, smooth

door closing will be affected. (See Fig.1)

Electric Strike Series

Magnetic Lock Series

Elect ric Bolt Lock ser ies

Brackets and Accessories

Mechanical Lock Se riess

Electronic Lo ck Se ries

Electric Strike Series

Magnetic Lock Series

Elect ric Bolt Lock ser ies

Brackets and Accessories

Mechanical Lock Se riess

Electronic Lo ck Se ries

Unlock Me thod

Door Frame

Main Page

Need help?

Do you have a question about the ZKTeco AL-300 and is the answer not in the manual?

ZKTeco AL-300 Specifications

General

Power Supply	4 x AA Batteries
Operating Temperature	-10°C to 55°C
Voltage	6V
Working Temperature	-10°C to 55°C
Housing Material	Zinc Alloy
Type	Fingerprint Door Lock
Access Method	Fingerprint, PIN Code
Battery Life	12 months