What to do if the ZKTeco SBTL8000 Other gate doesn't close after the delay?
If the barrier doesn’t close when the opening delay time is ended, check if the opening delay time is set too long or if the IR sensor is obstructed.
Why does only one speed gate unlock after swiping a card on my ZKTeco SBTL8000 Other device?
If only one speed gate unlocks after swiping the card, verify the mode setting of the master and slave devices, and check the 8-core and 2-core connection lines. Refer to the wiring diagram for the specific connection circuit.
What to do if the ZKTeco SBTL8000 swing arm is not in the normal closing position during self-test?
If the swing arm is not in the normal closing position during the gate's self-test, it may be due to obstacles. Remove any obstacles and restart the self-test after powering the device on.
How to fix a ZKTeco SBTL8000 mode indicator light that isn't responding correctly?
If the mode indicator light does not respond or the indication is incorrect, check that the control panel mode indicator wiring is correct or that the contact is poor.
To Next Page
General
