ZKTeco X6 - Admin and User Management; Create Administrator; Change Administrator; Forgot Administrator Password

Default Program Password : 1234 maximum finger : 500
CREATE ADMIN

exit (green light on and a long buzz)
CHANGE ADMIN


FORGOT ADMINISTRATOR PASSWORD
If the administrator password is lost, you can reset the password to default by using tamper switch.
Operation:
1. Dismantle the device and wait for 30 seconds until a short beep is heard.
2. Press the Tamper Switch thrice to reset to the initial administrator password.
 This operation must be done within 30 seconds; the default administrator password is 1234.
ADD/EDITUSER (finger)
Each user can resist 10 fingerprint and 1 card at most
Px) 
continue to add new users OR press [*] to escape(green light on
and a long buzz)
ADD CARD
Pmax)  card 2 times

long buzz)
ADD PASSWORD
The machine support at most 8groups of door password,
-

Note:
A. When a group of password was changed into 00000, then this group of password was shut down
B. When a group of password was changed successfully, you can input next group of number to modify
directly.
OPEN DOOR BY PASSWORD
Enter password and press # for verification