To Next Page
M
Michael ScottJul 25, 2025
Why is my Zline RA48 Ranges burner not igniting?
- LLaurie DominguezJul 25, 2025
The gas supply valve might be in the “OFF” position, or the gas supply to your Zline Ranges range may be interrupted.
Why is my Zline RA48 Ranges burner not igniting?
The gas supply valve might be in the “OFF” position, or the gas supply to your Zline Ranges range may be interrupted.
What to do if my Zline Ranges oven light is not working properly?
If the oven light in your Zline Ranges range isn't working, try replacing or reinserting the light bulb to ensure it is not loose or defective.
What to do if my Zline Ranges oven light stays on?
Check for any obstructions in the oven door of your Zline Ranges range. Also, inspect the hinge to see if it is bent.
General| Size | 48 inch |
|---|---|
| Color | Stainless Steel |
| Ignition Type | Electronic |
| Material | Stainless Steel |
| Burner Type | Sealed |
| Fuel Type | Natural Gas or Propane |
| Control Type | Knobs |
| BTU Rating (Burners) | 18, 000 BTU |
Covers warnings about airflow, manufacturer liability, domestic use, oven door safety, and installation codes.
Provides critical steps to take if a gas leak is detected, emphasizing safety precautions.
Covers electrical grounding, gas connection, flexible connectors, and pressure regulator requirements.
Details requirements for room ventilation and specifies gas pressure settings for natural and LP gas.
Specifies requirements for electrical receptacle and manual gas shut-off valve placement.
Details required clearances for installing the range adjacent to kitchen cabinets and vertical surfaces.
Lists the electrical power ratings for different models and the power consumption of heating elements.
Covers compliance with codes, gas supply line size, and sealant for pipe joints.
Details requirements for manual shut-off valves and approved flexible gas connectors.
Explains the function and installation of the pressure regulator for natural gas and LP gas.
Detailed steps on how to convert the pressure regulator from Natural Gas to LP gas.
Instructions for replacing surface burner nozzles as part of the gas conversion process.
