18
in the lower part of the “Video Preview” screen: Video Loss.
ALARM MANAGE OUTPUT: The length of time of the DVR will output the alarm
signal when an alarm is generated, with the options of 0 sec, 10 sec, 20 sec, 40
sec, and 60 sec
BUZZER: The length of time of the buzzer will sound when an alarm is generated,
with the options of 0 sec, 10 sec, 20 sec, 40 sec and 60 sec.
Post Alarm Recording: The time the DVR will continue to record after the motion
detection alarm is triggered, with the options of 30 sec, 1 min, 2 min, and 5 min,
Email SETUP: This unit supports motion detection and e-mail alarm.
Note: To receive e-mail notifications, the user must connect the DVR to a router
with internet access. See Chapter 4 DVR Network for the setup process.
When motion detection is triggered, the system will extract a picture at the
time of triggering and send it to the corresponding mailbox.
SSL: A secure link transmission protocol, where the Off or On state is determined
by the mailbox server.
SMTP PORT: The port used by the SMTP server that some e-mail services employ.
SMTP: The server address of the mailbox used. All information must be obtained
from the e-mail service provider. Zmodo is not responsible for the performance and
upkeep of mail servers.
SEND EMAIL: The mailbox address used to send mails.
SEND PW: The password of the mailbox used to send mails.
RECV EMAIL: The address used to receive the picture transmitted after the
DVR alarm is triggered. Please mind the space limitations of the e-mail inbox.
3.7.2 System Info
Enter the “System Info” screen from MAIN MENU → ADVANCED FUNCTIONS, as
shown below:
The software version number, whole unit version number, MAC address and serial
number are listed in this screen.
To Next Page
Loading...
