Why does my Zodiac Pool Systems AQUAPURE Ei say 'Check Salt'?
If your Zodiac Pool Systems Lighting Equipment displays a 'Check Salt' message, it could be due to several reasons. First, ensure the water temperature is above 65º F. Second, make sure the salt level is at least 3000 ppm. Finally, verify that both the salt and water temperature are at ideal levels.
What to do if my Zodiac Pool Systems AQUAPURE Ei Lighting Equipment shows 'No Flow'?
If your Zodiac Pool Systems Lighting Equipment indicates 'No Flow', first verify the water is touching the flag at the end of the blue wire. You can also test by placing a jumper temporarily between the black and blue wires on the three-pin connector (second and third pin from left to right) on the PCB. If the system reads flow with the jumper in place, then the power PCB is good, and the issue is likely with the cell terminals or cell wires.
What to do if fuses are blown on the PCB of my Zodiac Pool Systems AQUAPURE Ei Lighting Equipment?
If either or both fuses on the PCB of your Zodiac Pool Systems Lighting Equipment are blown, replace the PCB.
Step-by-step guide for attaching the cell to plumbing.
Diagnosing and resolving issues when the unit indicates no water flow.
Identifying and fixing problems related to salt levels and the 'Check Salt' indicator.
Information on hard resets, output faults, and additional operational notes.
Step-by-step guide for safely cleaning the electrolytic cell.
Common causes and solutions for insufficient chlorine production.
Diagnosing and fixing problems related to water flow detection.
Corrective actions for salt level indicators and faults.
General| Brand | Zodiac Pool Systems |
|---|---|
| Model | AQUAPURE Ei |
| Category | Lighting Equipment |
| Language | English |
To Next Page
