/ 12 8
INFLATING A NON AEROTEC BOAT (WITH BATTENS OR RIGID FLOOR)
Activate all valves in the inflation position.
Attach the hose connector to the inflator inflation
port.
To inflate your boat properly, the inflator should be
correctly placed on the ground.
The boat inflates rapidly if the inflator is used
smoothly and without haste.
CAUTION
DO NOT USE A COMPRESSOR OR COMPRESSED AIR CYLINDER.
You can us the electrical air pump ACCESS (ask your Dealer).
INFLATING THE BUOYANCY CHAMBER
(see "PRESSURE" section)
• Inflate the buoyancy mechanism, balancing the pressure between the different compartments
until the partitions (a) are no longer visible
(see "PRESSURE" section)
Never pressurise a
compartment when the
others are completely
deflated
a
1
2
INFLATING THE KEEL
(see "PRESSURE" section)
• Once the floorboard is installed, start inflation (see "PRESSURE" section)
Inflating is complete: screw on the inflating valve caps.
NOTE:
A slight air leak is normal before the valve cap is screwed on
ONLY THE VALVE CAPS CAN ENSURE FINAL AIR TIGHTNESS.
To Next Page
Loading...
Need help?
General