What to do if Zodiac V3 4WD Swimming Pool Vacuum cleaner does not stay firmly on the pool bottom?
If your Zodiac Swimming Pool Vacuum isn't staying on the pool bottom, it might be due to air trapped in the casing; repeat the immersion operations. Alternatively, the filter could be full or dirty, so cleaning it should solve the problem.
What to do if Zodiac Swimming Pool Vacuum does not move on start-up?
If your Zodiac Swimming Pool Vacuum doesn't move when started, verify that the outlet to which the control box is connected is receiving power. Also, ensure that you have started a cleaning cycle and that the indicators are on. If the problem persists, contact your reseller.
Why Zodiac V3 4WD robot does not or no longer climbs the pool sides?
The Zodiac Swimming Pool Vacuum might fail to climb pool sides if the filter is full or dirty, requiring cleaning. Microscopic algae in the pool water, even if the water appears clear, can also prevent climbing; perform a shock chlorination and slightly reduce the pH to resolve this. Also, avoid leaving the cleaner in the pool during shock treatments.
What to do if my Zodiac Swimming Pool Vacuum displays error code 4?
If your Zodiac Swimming Pool Vacuum displays error code 4, it indicates pump motor overconsumption. Check the fan for pebbles or hair and clean the filter.
Why Zodiac V3 4WD cable gets tangled?
To prevent the Zodiac Swimming Pool Vacuum cable from tangling, avoid unrolling the entire length of the cable into the pool. Place only the necessary length in the pool and leave the rest on the side.
What to do if my Zodiac V3 4WD displays error codes 5 to 6?
If your Zodiac Swimming Pool Vacuum displays error codes 5 to 6, it indicates overconsumption of the drive motors. Check that nothing is stopping the brushes from turning correctly, such as sand or cable. Turn the wheel to the left and then right one 1/4 turn in both directions.
Why Zodiac V3 4WD Swimming Pool Vacuum remote control has range problems?
If you're experiencing range problems with your Zodiac Swimming Pool Vacuum remote control, ensure the control box is placed on the caddy at least 3.5 meters from the pool. Orient the control box towards the pool to improve the remote control range and make sure there are no large objects between the control box and the pool.
What does it mean when the screen displays a message when the remote control mode is active on my Zodiac V3 4WD (V4 4WD)?
If the screen displays a message when the remote control mode is active on your Zodiac Swimming Pool Vacuum (V4 4WD), it means the remote control batteries are too low.
What to do if my Zodiac V3 4WD displays error codes 1 to 3?
If your Zodiac Swimming Pool Vacuum displays error codes 1 to 3, it indicates a cleaner malfunction. Please contact your reseller.
What to do if my Zodiac Swimming Pool Vacuum displays error code 10?
Check that the cleaner is correctly connected to the control box. If the problem continues contact your reseller.
General| Brand | Zodiac |
|---|---|
| Model | V3 4WD |
| Category | Swimming Pool Vacuum |
| Language | English |
To Next Page
