Need help?Do you have a question about the Zoetis AlphaTRAK 2 Meter and is the answer not in the manual?
General| Brand | Zoetis |
|---|---|
| Model | AlphaTRAK 2 Meter |
| Category | Blood Glucose Meter |
| Language | English |
Use only AlphaTRAK 2 test strips and control solution for accurate results.
Steps to perform a blood glucose test, including site selection and washing.
Verify meter display matches example. Do not use if mismatched. Contact Customer Care.
Use C/m buttons to match code on meter to test strip vial for accurate results.
Look for lines or listen for beep indicating enough blood. Add more if needed within 60s.
Result appears on display. Higher glucose levels take longer. Note error codes.
Low/high readings can signal serious medical conditions. Consult veterinarian.
Below 65 mg/dL (3.6 mmol/L). Repeat test, control test, consult vet if symptoms persist.
Above 250 mg/dL (13.9 mmol/L). Repeat test, control test, consult vet if symptoms persist.
Result < 20 mg/dL (1.1 mmol/L). Indicates severe low glucose. Symptoms listed for dogs and cats.
Result > 750 mg/dL (41.7 mmol/L). Indicates severe high glucose. Symptoms listed.
Sample too small, strip issue, meter error, or glucose < 20 mg/dL. Follow vet advice/control test.
Strip issue, meter error, or glucose > 750 mg/dL. Follow vet advice/control test.
Blood applied before symbols or strip insertion. Wait for symbols, perform control test.
Problem with test strip or meter. Perform control solution test.
m or C button pressed during sample application. Retest without pressing buttons.
Check strip insertion, battery installation, or replace dead battery.
Expired solution/strip, incorrect procedure, meter malfunction, wrong code, temperature issues.
Replace battery immediately when indicator appears to prevent meter failure.
Do not immerse the meter in water or other liquid to prevent damage.
To Next Page
