ZOJE ZJ-E007 - Presser Foot and Stitch Length

2.~'~iJ!.IgJt-t, ~H'LHH1~(3)&(4) , J:.l't li"W .. t.YZ.~~
!&tf(2) , il!.lflJ§f.d!~Z. .
@
A
IE Fig.10
2.To adjust ,loosen Screw (3) and (4),and move the
Spreader Thread Take-up {2)
up or down,and then
tighten screw again.
B
Ill Fig.11 Ill Fig.12
1- - - - - - - - - - - - - - - - - - - -.- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
ADJUSTING PRESSER FOOT
r -------- - ------------- ---- -- - -----------------------------
I f'kJHitf( I ); 1.i:titmi"W~:J. iJ!.IgffiJI!P(2); iitt:R~IXJU
I ~tlLT:lUJff-ZI=Pil,\,S o ir.JJIJ§, .jijf_tj!~~tf(I) . (IIJ I J)
I
I
Loosen Screw (1) and adjust Presser Foot (2) left and
right to a proper position to
let the needle may get into
the centre of Presser Foot 's
eyelet.After adjusting,
tighten screw (1) .(Fig.13)
r---------------------------- -- -- --------------------------
: ~~¥:lfii!Jf! ADJUSTING STITCH LENGTH
~------- - -------- - -------------------------------------- ---
!&~iflffij 1.2 .3¥. 4.0 rnm ~ 6- 18 HI i"1C~ftf2tt
il!.llt.
I, ffl-'f. ffil'nit!(A); .jij~:J.ti-'f.~fW-'f.~]lifJ1.i:-:f-m
5~nim~Ai~fll.HI*J$T-I*J .
2, r,J~~zw-'¥~ . iiM~PJT~z~ !§! ifJJt~lf£< s > ~J§
:!Dr1fnit! . (Ill I 5)
4, ttBezil!.lt~~ii~zwtt:~:;:. ~ttBeil!.lmJ§, mtt
f.Til!.lm~zwtl: .
- 5-
Stitch length can be adjusted variably in range from
1.2mm-4.0mm,or 6-18 stitches
per inch.
1.
Keep pressing the push butt on (A) with your left
hand, then turn the hand-wheel with your right hand
until your left hand finger feels the push button lock
in.(Fig 14)
2.Keep turning hand-wheel for an inquired stitch
length, whose scale indicated on the hand-wheel must
be
aligned with,then stop pressing the button.(Fig 15)
3.
Rotate the hand-wheel counter clock-wide to
increase the stitch
length,and clockwise to decrease.
4.After adjusting stitch
length the differential ratio will
usually
be changed too. So adjustment of differential
ratio is required.
-~ --------~------------------------ --
From the library of: Superior Sewing Machine & Supply LLC