Zojirushi cv-dcc40 User Manual

Condition
Cause
(
►
►
►
►
►
►
►
Remedy
)
A filmy, floating residue is
noticeable. (Could the Nonstick
Coating be peeling off?)
Residue is due to the mineral content in
water, not from corrosion of the Inner
Container or peeling of the Nonstick
Coaling.
Perform citric ac id cleaning .
(see pg . 17)
Scale
Over time and use, calcium
and other minerals
contained in water build up
on the surface of the Inner
Container and the Filter. It is
called "scale" and is
harmless to your health.
Milky white and rough-surfaced
objects have built up on the
surface of the Inner Container.
Excessive accumulation of scale and
other build-up on the surface of the Inner
Container can cause boiling to become
louder.
Boiling is louder than usual.
Red rust-like spotting appears
on the Inner Container surface.
Caused by iron in the water, not
deterioration of the Inner Container.
A white floating residue is
noticeable.
Remove the Inner Lid and check the
plastic part of the Upper Lid for
abnormalities. (see pg.16)
If this part is discolored or if it feels
rough to the touch , replace it.
Water is not hot.
Initially upon boiling or if it has been a
while after dispensing, the water may not
be very hot.
Please discard the first cup (of the
hot water) .
Is the Vacuum Insulation Keep Warm
mode selected? If yes, then power to
the heater has been turned off, causing
the water temperature to gradually drop.
Press the REBOIUQUICK TEMP
button . (see pg . 13 & 14)
Is the Timer set?
The Body becomes hot.
• When the water temperature and/or room temperature is high, the outer surface of
the Body may reach up to 140 °F (60 ° C) . This is not a malfunction .
The Power Cord becomes hot.
• The Power Cord may become hot while the water is boiling . This is not a malfunction .
You may hear a rattling or metallic
noise when opening and closing
the Upper Lid or during boiling.
• This sound is normal and comes from the movement of the weight which prevents hot
wa
t f
er rom
fl · t h th d t · rt d
owing ou w en e pro uc 1s ove urne .
Humidity builds in the Display
window.
e 11 water is filled from a faucet or the product is placed directly on a sink and the
bottom becomes wet , water may go inside of the Body and the Display may show
moisture . If this happens, stop using the product and allow it to dry as it may cause
short circuit or electric shock .
A beep sounds,
lights turn on and
"HH" appears on
the Display.
The Inner Container is
low on water or hot water
was added to the Inner
Container , causing the
Automatic Shut-Off
function to engage .
Unplug the Power Plug and
wait until the Inner Container
cools down . Add water and
plug in the Power Cord. (see
pg.11)
2 lights blink at the
same time and the
Display shows a
rotating square.
The Inner Container is in
a citric acid cleaning
cycle .
To cancel the citric acid
cleaning cycle , unplug the
Power Plug and wait more
than 5 seconds before
plugging back in. (see pg . 17)
[QJ or ~ is displayed .
Indicates malfunction .
Please contact Zojirushi Customer
Service .
Inner Lid Gasket
•
The Inner Lid Gasket is replaceable so please check it every year . When steam
comes out from the gap between the Upper Lid and the Body, or becomes white or
discolored , replace it with a new one. (see pg . 16)
Plastic Parts
• The plastic part of the Upper Lid may deteriorate over use . When replacing the Inner
Lid Gasket , check the plastic part . If discoloration occurs or the surface becomes
coarse, replace the Upper Lid (must purchase separately) . (We take care in only
using materials for the plastic parts that are safe and hygienic for food contac t. )
The Nonstick Coating of the Inner Container may become damaged over use. Contact the retail store where
you purchased this product or call Zojirushi Customer Service at: 1-800-733-6270
►
►
►
19

Zojirushi cv-dcc40 Specifications

General

Brand	Zojirushi
Model	cv-dcc40
Category	Boiler
Language	English