To Next PageTo Next PageWhat to do if the water shortage indicator light is on in my Zokop Ice Maker?
If the water shortage indicator light is on for your Zokop Ice Maker, it could be due to two reasons: either there is no water in the unit, or the pump is full of air. To resolve this, first add water to the MAX position. If that doesn't work, press the POWER button to restart the ice maker.
Why are the indicator lights not on on my Zokop Ice Maker?
If the indicator lights on the display of your Zokop Ice Maker are not on, the issue is likely due to a blown fuse or a lack of power. Try replacing the fuse. If that doesn't work, ensure the power is turned on.
How to fix Zokop Ice Maker when ice is too large and sticks together?
If your Zokop Ice Maker is producing ice that is too large and sticking together, it could be due to a couple of reasons. First, check if the wrong ice size is selected and change it to a smaller size. Second, if ice from previous cycles is left in the water tray, take it out under the standby state.
What to do if all indicators flash at the same time on my Zokop Ice Maker?
If all the indicators on your Zokop Ice Maker are flashing simultaneously, it could indicate a few potential issues. The water box might be blocked by ice. To resolve this, remove the ice under the ice shovel, plug the power in again, and press the POWER button. After 3 minutes, the machine will restart automatically.
Why does my Zokop ICM-2005 Ice Maker compressor make a buzzing noise?
If the compressor of your Zokop Ice Maker is working abnormally and making a buzzing noise, it's likely that the voltage is lower than recommended. Stop using the ice maker and do not restart it until the voltage is normal.
What to do if Zokop ICM-2005 doesn't display ice full icon?
If your Zokop Ice Maker does not display the ice full icon when it is full, it could be due to a damaged ice full sensor or solar light interference. Try replacing the ice full sensor or move the ice maker indoors to make ice.
Why is the water warming up in my Zokop Ice Maker?
If your Zokop Ice Maker has been working, but the water is warming up, the solenoid may have broken down. Replace the solenoid valve.
Diagram illustrating the ice maker's control panel with labeled components and indicators.
Step-by-step guide on using the control panel for ice making, cleaning, and mode selection.
This document describes the Zokop ICM-2005 ice maker, a household appliance designed for convenient ice production.
The Zokop ICM-2005 is an automatic ice maker that produces bullet-shaped ice. It offers quick ice making, with the ability to produce 9 pieces of ice in approximately 9 minutes and 30 seconds. Users can select between two different ice sizes: small and large. The device also includes an automatic cleaning function for ease of maintenance.
The ice maker features a control panel with several indicators and buttons. The display shows the ice making dynamic icon, cleaning icon, big ice icon, small ice icon, ice making icon, water shortage alarm, and water full alarm. The buttons include "Clean," "S/L" (Mode selection), and "On/Off" (Start/Stop).
Upon plugging in the power supply, the display will turn on, and the machine will initiate a deicing function. After a period of inactivity, it automatically enters standby mode. The "Start/Stop" button activates the ice making function, defaulting to big ice mode. The "S/L" button allows users to select the desired ice size. The "Clean" button, when pressed in conjunction with the "Start/Stop" button, activates a 150-second automatic cleaning cycle, after which the machine returns to standby.
The machine includes a time display that starts counting in minutes once ice making begins. This timer continues throughout the working period and resets to zero after reaching 99:99.
Safety features include a water shortage alarm, which activates if no water flow is detected within 5 seconds during pumping, causing the machine to stop operation. An "ICE FULL" indicator illuminates when the ice basket is full (detected by an infrared sensor being blocked for more than 5 seconds), at which point the machine pauses operation and the icon flashes. Ice production resumes once the sensor is clear.
To operate the ice maker, first open the lid, remove the ice basket, and add water to the reservoir. It is crucial not to exceed the "MAX" water level indicated inside the reservoir. If too much water is added, the excess must be drained via the bottom drain plug. Once water is added and the transparent lid is closed, plug in the power cord and press the "Start/Stop" button to begin. Users can then select their preferred ice size using the "S/L" button.
For optimal performance, it is recommended to choose small ice when the indoor temperature is below 15 degrees Celsius and large ice when the temperature exceeds 30 degrees Celsius. During the initial three cycles of use, the ice produced may be small and irregular. When the ice basket is full, it is important to remove the ice promptly to prevent overflow.
The ice maker is designed for household and similar applications, including staff kitchen areas, farmhouses, hotels, motels, and bed and breakfast environments. It is not intended for outdoor use.
Regular cleaning is essential for maintaining the ice maker. The inner liner, ice collecting tray, water box, ice shovel, and evaporator should be cleaned frequently. Before cleaning, always unplug the unit and remove any ice cubes. A diluted solution of water and vinegar can be used to clean both the inside and outside surfaces of the ice maker. It is important not to spray the ice maker with harsh chemicals or diluted agents such as acids, gasoline, or oil. After cleaning, rinse all components thoroughly before restarting the machine.
To ensure the cleanliness of the ice, it is recommended to change the water in the reservoir at least once a day. If the appliance will not be used for an extended period, drain the water completely and clean the unit.
The machine's ventilation openings should be kept clear of obstructions to ensure proper heat release. A minimum distance of 8cm from other objects is recommended, and at least 150mm from the back of the ice maker to a wall. Do not use mechanical devices or other means to accelerate the defrosting process beyond what is recommended by the manufacturer.
If the machine has been idle for some time, it may not have enough water to pump, triggering the "ADD WATER" indicator. In such cases, simply repress the "POWER" button to restart the ice maker. If the compressor experiences a strike action due to water shortage, a full water reservoir, or a power interruption, there will be a 3-minute delay before it restarts. Always use fresh water when starting ice production, whether it's the initial setup or after a long period of inactivity.
In case of a power failure or if the power button is pressed off during an ice making cycle, small ice chips might jam the automatic shovel. If this occurs, disconnect the power cord, gently push the shovel to the rear of the cabinet, remove the ice chips, and then restart. If the ice shovel cannot move ice to the basket, check if the water reservoir is flat; if not, gently push the ice shovel with a finger and press "POWER" to restart.
The appliance uses R600a refrigerant, which is flammable, as are the non-metallic materials. When disposing of the appliance, it should be taken to an authorized waste disposal center and not exposed to flame. The product is marked for correct disposal, indicating it should not be disposed of with other household waste in the EU. It should be recycled responsibly to promote sustainable reuse of materials.
General| Ice Production Capacity | 26 lbs per day |
|---|---|
| Ice Storage Capacity | 1.5 lbs |
| Water Reservoir Capacity | 2.2 L |
| Dimensions | 9.5 x 14.1 x 12.9 inches |
| Weight | 20 lbs |
| Power Consumption | 120W |
| Voltage | 115V |
| Material | Plastic |
| Frequency | 60Hz |
| Ice Making Current | 1.5A |
| Refrigerant | R134a |
| Ice Making Amount | 9 pcs per cycle |
| 24H Ice Making Amount | 26 lbs |
| Shape | Bullet |
| Ice Production | 26 lbs per day |
| Type | Ice Maker |
| Ice Size Options | Small, Large |
| Foaming Material | Cyclopentane |
| Climate Type | SN/N/ST |
| Ice Cube Size | Small, Large |
