Need help?Do you have a question about the ZONARE Z.one Ultra SP and is the answer not in the manual?
General| Type | Ultrasound System |
|---|---|
| Display Type | LCD |
| Battery Life | Up to 2 hours |
| Application | General Imaging |
| Imaging Modes | B-mode, M-mode, Color Doppler, Power Doppler, Pulsed Wave Doppler |
| Transducer Frequency Range | 1.0 MHz |
| Transducer Connectors | 3 |
Details critical warnings for safe system operation, transport, and electrical grounding.
Lists critical warnings related to battery handling, charging, and disposal.
Provides cautions regarding voltage, liquids, and transducer handling during service.
Step-by-step guide for safely uncrating the SmartCart SP system.
Steps for initial system checks, battery installation, docking scanner, and powering on/off.
Guides users through configuring system settings like Institution name, Audio/Video, Time/Region, and Trackball.
Introduces DICOM configuration requirements and network address information.
Defines parameters for DICOM configuration like AE Title, Color Model, Compression, and Date Range.
Details procedures for configuring DICOM settings like Location, General, Printers, Network Store, and MPPS.
Guides through configuring TCP/IP networking parameters and wireless network equipment setup.
Describes how to set up security passwords and access control for the system.
Step-by-step guide for installing or upgrading system software via USB.
Advanced steps for software installation when normal boot fails or software is corrupted.
Procedure for standard software installation on the Scan Module.
Clean installation procedure for Scan Module when docked in the Cart.
Clean installation procedure for Scan Module when undocked from the Cart.
Covers accessing and using the User Diagnostics Panel for system info and support.
Details approved disinfectants and cleaning/disinfection procedures for transducers.
Procedure for calibrating and verifying the Scan Engine's touchscreen.
Contact details for Zonare technical support in USA, Canada, Asia, and Europe.
Covers common troubleshooting steps for transducers, power-on, start-up, peripherals, and DICOM connectivity.
Explains system status icons and LED definitions for troubleshooting.
Detailed procedures for removing and replacing hardware components of the SmartCart SP.
Procedures for accessing and using the Diagnostics menu for service and firmware upgrades.
To Next Page
