42
routers must use the same setting.
MAC address: Input the MAC address of another wireless router.
Set Security: Click to set security settings for this connection
2-7-1-4. Setup procedure for AP Bridge-Point to
Multi-Point
In this mode, you can connect your wireless router with at least four wireless
routers to expand the scope of wireless network, and all clients (wired only –
AP will not accept wireless clients in this mode) of the wireless routers will
think they’re on the same physical network.
Band: Select the band you want to use, all the wireless routers must use
the same setting.
Channel Number: Select the channel you want to use, all the wireless
routers must use the same setting.
MAC address 1 to 4 (4 - 7): Input the MAC address of other wireless
routers.
Set Security: Click to set security settings for this connection
2-7-1-5. Setup procedure for AP Bridge – WDS
In this mode, you can expand the scope of network by combining up to four
other access points together, and every access point can still accept wireless
clients.
NOTE: For WDS mode, the output signal nature is the same as that of
To Next Page
Loading...
