What to do if my Zoomlion Excavators machine travels unsteadily?
If your Zoomlion Excavators machine is traveling unsteadily, adjust the tension of the tracks. Also, if stone or mud is blocked in the track frame, remove and repair it.
What to do if the radiator coolant level indicator light is on or the coolant temperature pointer points to the red zone in Zoomlion Excavators?
If the radiator coolant level indicator light is on or the coolant temperature pointer is in the red zone on your Zoomlion Excavators, the cooling fin may be blocked or damaged, so clean or repair it. Another potential cause is thermostat fault, so change the thermostat. The lid of the coolant injection port on the radiator may be loose (especially during high altitude operation), so fasten the radiator lid or change the seal. Finally, the coolant level and temperature sensors may be faulty, or the indicator itself may be faulty, so change the sensor.
What to do if the hydraulic cylinder works but can’t hoist the load on my Zoomlion Excavators?
If the hydraulic cylinder on your Zoomlion Excavators works but cannot hoist the load, ensure that the hydraulic oil level is sufficient by adding oil. Also, check the suction filter for blockages and clean the filter and the system. Finally, check the suction pipeline of the pump for leaks.
Why is the vapor squirting from the top of the radiator (the pressure valve) in my Zoomlion ZE230E?
If vapor is squirting from the top of the radiator (pressure valve) in your Zoomlion Excavators, it could be due to a low coolant level or a water leak. Check the coolant level, add water if necessary, and repair any leaks. Also, a loose fan belt can cause overheating, so check the tension of the fan belt and adjust or replace it. Another potential cause is accumulation of dirty things or lime scale in the cooling system, so change the cooling liquid and wash the interior of the cooling system.
What to do if the hydraulic pressure functions slowly in Zoomlion ZE230E?
If the hydraulic pressure in your Zoomlion Excavators is functioning slowly, it could be due to several reasons. First, check the oil level and refill the oil collector to the full scale if it is low. Also, if the oil is cold, preheat the machine. If the engine speed is too low, increase the speed.
What to do if my Zoomlion ZE230E Excavators engine oil pressure indicator light is on?
If the engine oil pressure indicator light is illuminated on your Zoomlion Excavators, several factors could be responsible. Start by checking the engine oil filter; if it's blocked, replace it. Additionally, inspect the oil pipe and joints for looseness or damage that may be causing leaks and repair if needed. Also, the engine oil pressure sensor could be faulty and require replacement, or the indicator itself may be faulty, requiring replacement.
What to do if my Zoomlion ZE230E Excavators engine doesn’t start when the starter motor rotates?
If your Zoomlion Excavators engine doesn't start even when the starter motor is rotating, it could be due to several reasons. First, ensure you have enough fuel by refueling. Secondly, there might be air in the fuel system, requiring you to repair the part that's sucking in air. Another potential cause is a faulty injection pump or nozzle, which would need replacement.
excavator zoomlion z e 230 e requires unlock code, changed batteries. excavator 2013. engine starts, works. but hydraulics are in the block, requires four-digit code
excavator zoomlion z e 230 e requires unlock code, changed batteries. excavator 2013. engine starts, works. but hydraulics are in the block, requires four-digit code
General| Brand | Zoomlion |
|---|---|
| Model | ZE230E |
| Category | Excavators |
| Language | English |
To Next Page
