©2018 Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following document are registered trademarks of Zortrax and are subject to legal protection. | www.zortrax.com
06.11.2018
42 31
86 75
Fill the tank with resin. The resin level must fit the
MIN and MAX marks. Install the UV cover back on
the printer.
Transfer the file from Z-SUITE to the printer (via
Wi-Fi/Ethernet or using the USB drive) and start the
printing process.
Once the printing process is finished, wait until the
resin fully drains off of the model. Remove the UV
cover.
*Depending on the size and geometry of the model,
you can use the platform rotating jig from the
Starter Kit to save more liquid resin.
Remove the UV cover. If you haven't calibrated the
platform during the set-up of the printer, carry out
this procedure now.
Leave the platform with the model to air dry and
ensure that the model isn’t exposed to the UV light
until it’s completely dry. Next, remove the model
from the platform by hand or use a spatula. If you
have problems with removing the print, use a
cutting knife.
Immediately put the platform with the model in the
Ultrasonic Cleaner. The model cannot be exposed
to the UV light. Turn on the device. Cleaning time
depends on the size of the model, but it shouldn’t
exceed three minutes. Longer cleaning time causes
the liquid to heat up.
Turn off the Ultrasonic Cleaner and remove the
platform with the model.
Wipe the top and edges of the platform with a
paper towel and unscrew the platform screw (A).
Remove the platform (B). Be careful not to spill the
liquid resin on the printer and its surroundings.
Install the UV cover on the printer.
A
B
min
max
• Wear protective clothing, gloves and glasses during all procedures.
• Prepare paper towels and keep them in your workplace for wiping up liquids.
• Printing and post-processing waste, including empty bottles, failed prints, supports, rafts as well
as paper towels with resin residues should be put in the UV Station or in any source of UV light
before disposal. Uncured resin has to be disposed of in accordance with national and local
regulations concerning hazardous waste.
• Detailed information regarding usage and waste disposal of the liquid detergent utilized to clean
3D prints should be found in the SDS delivered by the producer of the liquid.
To Next Page
Need help?
General
