Need help?Do you have a question about the zortrax M300 Plus and is the answer not in the manual?
General| Build Volume | 300 x 300 x 300 mm |
|---|---|
| Filament Diameter | 1.75 mm |
| Nozzle Diameter | 0.4 mm |
| Connectivity | Wi-Fi, Ethernet, USB |
| Operating System | Windows, macOS |
| Software | Z-SUITE |
| Supported File Types | .stl, .obj, .dxf, .3mf |
| Layer Resolution | 0.05 - 0.3 mm |
| Supported Materials | Z-ASA Pro, Z-ESD, Z-GLASS, Z-HIPS, Z-PETG |
| Operating Temperature | 15 - 30 °C |
| Power Supply | 110/240 V AC |
| Weight | 40 kg |
Turn off the printer and unplug the power cable.
Detach the material guide from the extruder cover and separate it from the cable.
Detach the extruder upper printed cover and unplug the extruder cable.
Change the printer's position to easily access the bottom plate.
Unscrew bottom plate securing screws on one side of the housing using a 2.5mm Allen key.
Physically turn the printer over to access the bottom plate.
Unscrew bottom plate securing screws on the other side of the housing.
Separate the bottom plate and unplug the bottom fan cable from the motherboard.
Information about the new motherboard version and extruder cable connection.
Separate the adapter from the extruder cable for the new motherboard.
Remove the extruder cable by unfastening straps and passing it through the hole.
Assemble the extruder cable by securing straps and plugging into the motherboard.
Information about the old motherboard version and extruder cable connection with adapter.
Remove the extruder cable from the old motherboard by unfastening straps.
Assemble the extruder cable for the old motherboard by securing straps and plugging it in.
Plug the bottom fan cable and install the bottom plate.
Secure the bottom plate on one side of the housing with a 2.5mm Allen key.
Turn the printer over during the reassembly process.
Secure the bottom plate on the other side of the housing using the same key.
Set the printer upright after securing the bottom plate.
Plug the extruder cable in and attach the extruder upper cover.
Attach the material guide to the extruder cover and secure it to the cable.
Plug the printer's power cable back in.
To Next Page
