Zotac VR GO

ZOTAC VR GO
27
Using a dynamic IP (PPPoE connection)
1. Repeat Step 1-3 in the previous section.
2. Select “Obtain an IP address automatically” and click “OK”.
3. Click “Create a new
connection” to start the NEW
Connection Wizard.
4. Click “Next”.
5. Select “Connect to the
Internet” and click “Next”.
6. Select “Set up my
connection manually”.
7. Select your connection
type and click “Next”.
8. Enter your ISP Name and
click “Next”.
9. Enter your User name and
Password. Click “Next”.
10. Click “Finish” to nish the conguration.
11. Enter your user name and password. Click “Connect” to connect to the internet.
Note: Contact your internet Service Provider (ISP) if you have problems connecting to the network.
Conguring audio output
Follow the steps below to enable audio output when connecting
the ZOTAC VR GO to a TV or receiver via DP/HDMI adapter.
1. Access the Sound settings via the system Control Panel.
2. Under Playback devices, click the display device that
corresponds with your audio compatible display.
3. Click the “Set Default” button in the lower right hand corner.
4. Click “OK” to exit the setup.