8 9
Setting Up Your Phone
The nano-SIM card(s) can be installed or removed while the
phone is turned on.
WARNING!
To avoid damage to the phone, do not use any other kind
of SIM cards, or any non-standard nano-SIM card cut from a
SIM card. You can get a standard nano-SIM card from your
service provider.
1. Insert the tip of the tray eject tool into the hole on the
card tray.
CAUTION:
Never replace the included tray eject tool with sharp
objects. Ensure that the tray eject tool is perpendicular to
the hole. Otherwise, the phone may be damaged.
2. Pull out the card tray and place a nano-SIM card into
the card slot on one side and another nano-SIM card or
a microSDXC card (optional) into the card slot on the
other side, as shown. Note the notch and the shape
of the cards and the card slots. Carefully slide the tray
back into place.
NOTE:
If two nano-SIM cards are installed, you can use either
card for mobile data and that card can connect to the 5G
network.
Charging the Phone
Your phone’s battery should have enough power for the
phone to turn on, find a signal, and make a few calls. You
should fully charge the battery as soon as possible.
WARNING!
Use only ZTE-approved chargers and USB Type-C cables.
The use of unapproved accessories could damage your
phone or cause the battery to explode.
WARNING!
Do not remove the back cover. The battery is not
removable. Removal may cause fire or explosion.
To Next Page
Loading...
