Zte Blade A3 Lite - FCC Regulations and RF Exposure; FCC Compliance Statement; RF Exposure Information

To Previous Page

Do not attempt to disassemble your phone.

Only use approved accessories.

Don’t rely on your phone as a primary device for emergency communications.

Please visit https://certification.zetdevices.com and select your product type for more information on FCC RF Exposure information and SAR value

for this device.

SAR compliance for body-worn operation is based on a separation distance of 10 mm between the unit and the human body. Carry this device at least

10 mm away from your body to ensure RF exposure level compliant or lower to the reported level. To support body-worn operation, choose the belt

clips or holsters, which do not contain metallic components, to maintain a separation of 10 mm between this device and your body.

RF exposure compliance with any body-worn accessory, which contains metal, was not tested and certiﬁed, and using such body-worn accessory

should be avoided.

FCC Regulations

This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or