Remove the battery if the device will be unused for a long period.
The battery is intended for backup purposes only (in the event of
a power failure).
The device takes about 5 hours to charge fully. The charge time
may be impacted by environmental factors.
Turning on Your Device
Plug the power cord into an electrical wall outlet that is not controlled
by a wall switch.
Insert the small end of the power cord into the Power Input port on the
back of your Wireless Home Phone Base.
Slide the On/Off switch to On position.
Checking the Wireless Signal
1. Raise antenna to an upright position.
To Next Page
Loading...
Need help?
General
