Zte zpad - Page 53

53
1. Touch > > Settings > Wi-Fi.
2. Slide the Wi-Fi switch to the On position.
3. Touch > Saved networks.
4. Touch the Wi-Fi network name and then touch FORGET.
Adjust Advanced Wi-Fi Settings
1. Touch > > Settings > Wi-Fi.
2. Touch > Advanced to adjust the following settings.
 Network notification: Get notifications in the status bar when Wi-Fi is on and an
open network is available.
 Scanning always available: Allow some services to scan for networks even when
Wi-Fi is off.
 Keep Wi-Fi on during sleep: Set whether to keep Wi-Fi on in sleep mode.
 Install certificates: Install certificates needed for connecting to certain Wi-Fi
networks.
 Wi-Fi Direct: Use the Wi-Fi Direct feature. See Using Wi-Fi Direct
®
.
 WPS Push Button: Connect to a WPS network via the push button method.
 WPS Pin Entry: Connect to a WPS network via the device PIN method.
 MAC address: Check the MAC address.
 IP address: Check the device’s IP address.