ZXV10 W300 Wireless ADSL Router User's Manual
192.168.1.1.
5) Configure Use the following DNS server
addresses. To set the DNS server IP addresses, please
contact your local Service Provider, or set it to
192.168.1.1.
6) Click OK twice to confirm and save your settings.
After the completion of the above configuration:
1. If the device is set to the Bridging mode, you can
access the Internet according to the service provided by
the Service Provider.
2. If the device is set to the Routing mode, you can
access the Internet directly after a connection is
established between the ZXV10 W300 device and the
office-end device.
3. To check the device configurations, visit
http://192.168.1 via a browser and log on to the device.
Logged users are classified into 2 levels:
Administrator level, with "admin" as both username
and initial password. All functions of the ZXV10
W300 can be set up.
General user level, with "public" as both username
and initial password. General users can only monitor
the operating status of the device.
Note:
Be sure to remember the password of the ZXV10 W300.
To Next Page
Loading...
