Zundapp 281 - Page 36

x)
Assembly of Kickstarter.
If
the
left-hand
casing
cover
had
been
completely
dismantled,
first
fit
starter
spring
in
such
a
way
that,
seen
towards
the
inside
of
the
cover,
the
spring
can
be
tensioned
anti-
clockwise.
Grease
the
spring
well.
Then
introduce
the
small
stop
nose
of
the
cover
plate
into
the
inner
spring
loop,
and
fit
the
sleeve,
kick-
starter
pedal
lever
facing
up,
through
the
plate
from
the
other
side;
remember
checkplate
between
casing
gover
and
sleeve.
Hold
the
casing
cover
with
one
hand,
then
pre-tension
kickstarter
spring
by
turning
kickstarter
pedal
lever
through
about
1
revolution,
until
the
stop
nose
lies
just
in
front
of
the
top
stop
on
the
casing.
Finally,
fit
the
snap
ring
(fig.
95).
Mounting Fan, Left Casing Cover
with Kickstarter and Fan Casing
Fit and bolt fan to flywheel magne-
to with 4 cylindrical screws, M5 x 20
(fig. 96).
The following can only be carried
out after engine has been fitted
into frame:
Fit casing cover on left and bolt
down with two hexagon bolts, M 6
x 35 (fig. 97).
On air-cooled engines,
fit 2 cylindrical bolts,
M6x45.
Fit sealing ring of pedal gear
change spindle into sleeve of kick-
starter, using sleeve MV 6-1563 and
hollow punch MV 6-347 (fig. 98).
36