Chapter 4 Web Configurator
GS1920v2 Series User’s Guide
59
Figure 41 Web Configurator Layout
A – Click the menu items to open sub-menu links, and then click on a sub-menu link to open the screen
in the main window.
B, C, D, E, F, G, H
– These are quick links which allow you to perform certain tasks no matter which screen
you are currently working in.
B
– Click this icon to go to the NCC (Nebula Control Center) portal website.
C – Click this icon to search for specific configurations or status you are looking for. Enter the keywords
and click the result link. This will direct you to the specific configuration or status page.
D – Click this icon to update the information in the screen you are currently viewing.
E
– Click this icon to save your configuration into the Switch’s non-volatile memory. Non-volatile memory
is the configuration of your Switch that stays the same even if the Switch’s power is turned off.
F
– Click this icon to display web help pages. The help pages provide descriptions for all of the
configuration screens.
G
– Click this icon to go to the Zyxel Community Biz Forum.
H
– Click this icon to log out of the Web Configurator.
I
– This displays the Nebula Cloud Control Status. The ON/OFF switch displays if NCC Discovery is
enabled. If a status circle turns Orange, it means the Switch is unable to connect to NCC. Hover the
mouse over the status circle to check the diagnostic message. You can also click the ON/OFF switch to
go to the SYSTEM > Cloud Management screen and check the diagnostic messages. See Section Table
27 on page 113 for more information.
In the navigation panel, click a main link to reveal a list of sub-menu links.
To Next Page
Loading...
