5
Figure 5. Installation is finished.
1.2 NSA310S Initialization
After a successful installation, click on the “NAS Starter Utility”. The first
screen of the NSU will try to discover the NSA devices. Click on “NAS
Seeker”, and then choose the devices that you want to connect.
Figure 6. NAS Discovery. Figure 7. NAS Seeker.
Then click Run the Initialization Wizard to setup the NSA310S, and enter
the username and password to start the initialization. The default username is
admin and the password is 1234. These two words are case sensitive.
Figure 8. Run Initialization. Figure 9. Enter username and password.
To Next Page
Loading...
