ZyXEL Communications NSA320 - NSA320 Initialization

Figure 5. Installation is finished.
1.2 NSA320 Initialization
After successful installation, click the “NAS Starter Utility”. The first screen of NSU
shows the result of NSA Discovery. Click your NSA320’s button and click Run the
Initialization Wizard to set up the NAS320. If the connection is green, it means this
NAS is able to be reached by the PC shown in the screen. If the connection is red, this
NAS is not able to be accessed by the PC.
Figure 6. NAS Discovery.
Figure 7. Run Initialization
Then enter the username and password to start the initialization. The default
username is admin and the password is 1234. These two words are case sensitive.
Figure 8. Enter username and password.