Chapter 9 Network
Media Server User’s Guide
174
The following table describes the labels in this screen.
Table 28 Network > TCP/IP
LABEL DESCRIPTION
IP Address
Dynamic Select this option to have the NSA get IP address information automatically.
If no IP address information is assigned, the NSA uses Auto-IP to assign itself an IP
address and subnet mask. For example, you could connect the NSA directly to your
computer. If the computer is also set to get an IP address automatically, the computer
and the NSA will choose addresses for themselves and be able to communicate.
Static Select this option for the NSA to use fixed TCP/IP information. You must fill in the
following fields.
IP Address Type an IP address in this field.
IP Subnet Mask Type an IP subnet mask in this field.
Default Gateway Type a default gateway address in this field.
IPv6 Settings Click this to open a screen where you can configure IPv6 address settings.
Mode: Select Auto to have the NSA use the IPv6 prefix from the connected router’s
Router Advertisement (RA) to generate an IPv6 address. Select Static to manually
enter a fixed IPv6 address. Select Disable to have the NSA not use IPv6.
Address: For static mode, enter the fixed IPv6 address here.
Subnet prefix length: For static mode, enter the IPv6 prefix length here.
Default Gateway: For static mode, enter the IPv6 address of the default gateway
here.
Click Apply to save and apply your settings or click Cancel to close this screen without
saving changes.
DNS DNS (Domain Name System) is for mapping a domain name to its corresponding IP
address and vice versa. If you have the IP address(es) of the DNS server(s), enter
them.
Dynamic Select the option to have the NSA get a DNS server address automatically.
Static Select this option to choose a static DNS server address. Type the DNS server IP
address(es) into the fields below.
Primary DNS
Server
Type a primary DNS server IP address.
Secondary DNS
Server
Type a secondary DNS server IP address.
HTTP (Web Configurator)
Enable Another Web
Configuration Port
Select this to configure an additional HTTP port for accessing the web configurator.
Specify a number in the Port Number field.
To Next Page
Loading...
