ZyXEL Communications NSG100 - The Web Configurator; Accessing the Web Configurator

Chapter 3 The Web Configurator
NSG Series User’s Guide
11
CHAPTER 3
The Web Configurator
See Section 1.1 on page 5 to see when you need to use the Web Configurator.
In order to use the Web Configurator, you must:
• Use one of the following web browser versions or later: Internet Explorer 10.0 and later versions, Mozilla
Firefox 36.0 and later versions, Safari 9.0 and later versions, or Google Chrome 38.0 and later versions
• Allow pop-up windows (blocked by default in Windows XP Service Pack 2)
• Enable JavaScripts, Java permissions, and cookies
The recommended screen resolution is 1024 x 768 pixels.
3.0.1 Web Configurator Access
1 Make sure your NSG hardware is properly connected. See the Quick Start Guide.
2 In your browser go to http://(IP assigned by NCC) or http://192.168.1.1. See Section 1.1 on page 5 for
more information. By default, the NSG automatically routes this request to its HTTPS server, and it is
recommended to keep this setting. The Login screen appears.
3 Type the user name (default: “admin”) and password (default: “1234”). If the NSG is being managed or
has been managed by the NCC, check the NCC's Site-Wide > Configure > General setting screen for
the NSG's current password.
4 Click Login. After you log in for the first time using the default user name and password, you must
change the default admin password in the Update Admin Info screen. Type a new password of up to 63
printable characters without spaces, then click Apply.