Chapter 1 Introduction
NSG Series User’s Guide
6
If the NSG is registered to a site in the NCC and its firmware is not up-to-date, the NSG firmware will be
upgraded according to the device-specific schedule or the site-wide schedule configured in the NCC.
Go to the NCC to configure the following settings:
•VPN
• Firewall
• IDP (Intrusion Detection and Protection)
• Content filtering
•Anti-virus
• Application patrol
•Bandwidth management
• NAT
•Port forwarding
• Policy routing
•DHCP server
Use the Web Configurator
This User's Guide shows you how to use the web configurator.
Access the NSG’s built-in Web Configurator to:
• Check the Internet connection if the NSG can’t be managed by the NCC
• Check the system status
• Configure WAN connection settings
• Collect diagnostic information
To Next Page
Loading...
