4
1. DSL: Use a telephone cable to connect your P-660HN-51’s DSL port
to a telephone jack (or to a splitter, if one is already installed).
2. LAN: Use an Ethernet cable to connect a computer to a LAN port for
initial configuration and/or Internet access.
3. POWER: Use the power adaptor provided with your P-660HN-51 to
connect an appropriate power source to the POWER socket. Make
sure the power at the outlet is on. After connecting the power adapter,
look at the lights on the front panel.
• The POWER light blinks while your P-660HN-51 starts up and then
stays on once it is ready. The DSL light turns on when the P-
660HN-51 has a DSL connection. The WPS light turns on when the
wireless LAN is ready. The INTERNET light turns on when the
gateway is able to access the Internet and will blink when the P-
660HN-51 is sending or receiving data.
• Each LAN light stays on if the corresponding LAN port is properly
connected and blinks when there is traffic.
If the POWER, DSL, or connected LAN lights are not on, please check
your connections and inspect your cables for damage. If the lights are
still off, contact technical support.
To Next Page
Loading...
