6
Set Up a Wireless Network Manually
The wireless LAN on your P-660HN-51 is enabled by default. To add a
wireless client to the network, use the settings found on the bottom panel
of your P-660HN-51, which will look similar to the following example:
Configure wireless devices that you want to connect to the wireless
network to use the same wireless settings as the P-660HN-51.
The default wireless settings vary for each P-660HN-51. Refer to the
bottom panel of your device and use the provided information.
Log into the Web Configurator
Your device may already be set up for Internet access. However, you
may want or need to log on to the P-660HN-51 Web Configurator to
perform tasks:
• Configure your Internet access settings manually
• Customize the Quality of Service (QoS) and routing features
• Create firewall and web filter rules
• Edit remote management, as well as other features
1. In your browser, go to http://192.168.1.1.
To Next Page
Loading...
