ZyXEL Communications PLA-400 v2 - Page 4

ENGLISH
4
2 Connecting the PLA-400 v2 to a Computer
1 Use an Ethernet cable to connect the LAN port (A) on the PLA-400 v2 to the Ethernet
port (B) on your computer.
2 Connect the PLA-400 v2 to a power outlet.
3 The power ( ) light should be on and the Ethernet ( ) light should be on or blinking. If
these lights are not on, unplug your device and recheck your hardware connections.
• If the HomePlug ( ) lights turn on the first time you set up your PLA-400 v2s, your
HomePlug AV network is ready for use. However, the PLA-400 v2s may both be using
the default network name HomePlugAV. This well-known network name allows access to
your HomePlug AV network. You can make your network name more secure by going to
the next section to set up a HomePlug AV network with ENCRYPT.
• If the HomePlug ( ) lights do not turn on, go to the next section to set up a HomePlug
AV network with ENCRYPT.
A
B