ZyXEL Communications U-336E - Page 68

56 Fax Operation
Command Value Description
ln,df,ec,bf,st +FDCC command in Class 2 for
parameter settings.
+FCLASS=n Service class selection. Refer to
+FCLASS Class 1 command in previous
section.
+FCO DCE response fax connection made.
+FCQ=<rq>,<t
q>
Copy quality check capability parameter
rq=0 DCE Receive Copy Quality Checking
disabled.
rq=1 DCE Receive Copy Quality Checking
enabled.
rq=2 DCE Receive Copy Quality Correction
enabled.
tq=0 DCE Transmit Copy Quality Checking
disabled.
tq=1 DCE Transmit Copy Quality Checking
enabled.
tq=2 DCE Transmit Copy Quality Correction
enabled.
+FCR=n "Capability to receive" parameter
n=0 DCE will not receive message or poll a
remote device.
n=1 DCE receives message data or polls a
remote device
+FCT=n 0-255 DTE phase C time-out parameter. n=0-
255, 1s units.
+FDR Receive phase C data command initiates
document reception
+FDT Transmit phase C data command:
releases the DCE to proceed with
negotiation
+FEA=n Phase C received EOL alignment