Fax Operation 57
Command Value Description
parameter
n=0 Determine that T.4 EOL patterns are bit
aligned (as received).
n=1 Determine that the last received bits of
T.4 EOL patterns are byte aligned by
the DCE, with necessary zero fill bits
inserted.
+FIE=n Procedure interrupt parameter
n=0 Procedure interrupt requests from the
remote station are ignored, and not
reported to the DTE.
n=1 Procedure interrupt requests from the
remote station are accepted, negotiated
and reported using the +FVO response.
+FIP Initialize facsimile parameters to factory
default.
+FIS=vr,br,wd,l
n,df,ec,bf,st
Current session parameter. refer to
+FDCC Class 2 command in previous
section parameter settings.
+FKS Session termination command.
+FLI="string" Local ID string parameter.
+FLO=n Flow control options:
n=0 No flow control.
n=1 Set XON/XOFF software flow control.
n=2 Set CTS/RTS hardware flow control.
+FLP=n Document for polling command:
n=0 The DTE has no document for polling.
n=1 Indicated document available for
polling.
+FMI? Request DCE manufacturer
identification.
+FMM? Request DCE model identification.
To Next Page
Loading...
