ZyXEL Communications U-336E - Page 70

58 Fax Operation
Command Value Description
+FMR? Request DCE revision identification.
+FMS=n Minimum phase C speed parameter.
refer to +FMINSP Class 2 command in
previos section for parameter settings.
+FNR=rpr,tpr,
idr, nsr
Negotiation message reporting control
parameters:
rpr=0 Receiver parameters are not reported.
+FIS: and +FTC: response reports are
suppressed.
rpr=1 Receiver parameters are reported. +FIS:
and +FTC: response reports are
generated.
tpr=0 Transmitter Parameters are not
reported. +FCS: response reports are
suppressed. (+FCS parameter is still
loaded)
tpr=1 Transmitter Parameters are reported.
+FCS: response reports are generated.
idr=0 ID Strings are not reported. +FTI:
+FCI: and +FPI: response reports are
suppressed.
idr=1 ID Strings are reported. +FNF:, +FNS:
and +FNC: response reports are
generated.
nsr=0 Non-standard frames are not reported.
+FTI: +FCI: and +FPI: response reports
are suppressed.
nsr=1 Non-standard frames are reported.
+FTI:, +FCI: and +FPI: response
reports are generated.
+FNS="string" Non-standard byte string parameter.
"string": string of hexadecimal coded
octets.