102 AT Command Set Summaries
Command Options
Function & Description Ref.
*In Command set selection S17.6-7
*I0 * AT command set
*I1 V.25bis command set
*I2 Dumb mode
*Mn Leased line auto-handshake mode
selection
S14.0
*M0 Set to Originate mode
*M1 Set to Answer mode
*Pn n=0-15
*P9 *
Set leased line transmission power
level; ranges from 0 dBm to -15 dBm
(default: -9 dBm) (see also S35.3)
S17.1-4
*Qn Action taken when line quality
changes.
S27.6-7
*Q0 No action to poor signal quality.
*Q1 Retrain action taken if signal quality is
poor. (See also S41.2)
*Q2 * Adaptive rate, automatic fall-back or
forward.
*Q3 Disconnect if signal quality is poor.
*Rab Read remote profile “b” to local user
profile “a”
S36.1
a=0-3 Local user profile number “a” S37.4-7
b=0-3 Remote user profile number “b” S37.0-3
b=4 Remote active configuration
b=5 Remote factory default configuration
*Sn Secondary channel options
*S0 * Secondary channel disabled
*S1 Secondary channel enabled
*T Recall the last CND (Caller ID)
information.
S40.2
To Next Page
Loading...
