ZyXEL Communications U-336S - Extended S-Registers Atsn=X

106 Status Registers & Result Codes
Command Function & Description +Ref.
register also sets the time-out interval for the
“W” dial modifier to wait for the dial tone. (See
also S41b4)
S7= Set duration, in number of seconds modem
waits for a carrier
+060
S8=
Set duration, in seconds, for pause (,) option in
Dial command and pause between command
re-executions for Repeat (>) command
+002
S9= Set duration, in tenths of a second of remote
carrier signal before recognition (Ignored if in
non-FSK or half-duplex operation)
+006
S10= Set duration, in tenths of a second, modem
waits after loss of carrier before hanging up
+007
S11= Set duration and spacing, in milliseconds, of
dialed Touch-Tones
+070
Extended S-Registers "ATSn=x"
Command bit dec hex Function and description Ref.
S13= bit dec hex Bit-mapped register +000
1 2 2 Capture modem manufacturer
information during V.42
handshake, can be displayed at
ATI2 <Last Speed/Protocol>
line if available (‘Flash’ or ‘
ZyXEL’ stands for ZyXEL
connection)
S14= bit dec hex Bit-mapped register: +002
0 0 0 Modem auto-handshake on
Originate mode
*M0
1 1 Modem auto-handshake on
Answer mode
*M1