Fax Operation 69
Command Value Description
+FBADLIN=
<value>
0-255 Bad line threshold (number of
consecutive bad lines for a bad page
parameter):
Determine if Copy Quality OK on the
T.30 flow chart . <value>=0 to 255; a
value of 0 implies that error checking is
disabled.
+FBOR=n Phase C data bit order:
n=0 Select direct bit order.
n=1 Select reversed bit order in receiving
mode for phase C data.
+FBUF? Buffer size; read only parameter:
Allow DTE to determine the
characteristics of the DCE’s buffer size.
+FCIG="string" Local fax station ID string, for polling Rx.
+FCLASS=n Service class selection: Refer to
+FCLASS Class 1 command in previous
section.
+FCON DCE responds fax connection .
+FCQ=n Copy quality check capability parameter
n=0 No copy quality check capability.
n=1 Only check 1D phase C data.
n=2 Check both 1D and 2D phase C data.
+FCR=n "Capability to receive" parameter
n=0 DCE will not receive message data or
poll a remote device.
n=1 DCE receives message data or polls a
remote device.
+FDCC=vr,br,wd
,ln,df,ec,bf,st
DCE capabilities parameters.
vr=0 Vertical resolution: Normal; 98 lpi.
To Next Page
Loading...
